Removal

REMOVAL





WARNING: Before proceeding with the following repair procedure, review all warnings and cautions.

1. Remove the passenger or drivers front seat.

2. Remove the seat weight sensors if equipped, passenger seat only.





3. Disconnect the electrical connectors and remove the occupant classification module.





4. Remove the electrical harness connectors from the OCS mounting plate.





5. Remove the electrical connectors for both the heated seat back and seat elements.





6. Remove the recliner handle.

7. Remove the two screws from the side of the outer seat trim.





8. Remove the two screws from the rear of the outer seat trim and remove the trim panel.

9. Remove the seat position sensor.






CAUTION: The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to prevent binding that could result in tab breakage.

10. Position the right front seat to the full rearward position.

11. Disconnect and isolate the battery negative cable.

12. Disconnect the wire harness connector (4) from the heated seat module (3).

13. Unsnap the heated seat module retaining tab (2) from the seat pan (1).

14. Remove the heated seat module (3) from the vehicle.

15. Remove the three nuts and remove the left seat track.

16. Remove the three nuts and remove the right seat track.

17. Remove the electrical harness from the seat bottom.





18. Remove the recliner cable from the left and right side of the seat.





19. Remove the two seat frame bolts from the left and right side of the seat.

20. Separate the seat bottom and the seat back.