Removal

LEFT HAND DRIVE (LHD)




1. Disconnect the wire (3) to the fluid level switch at the bottom of the reservoir (2).
2. Remove the master cylinder (2).
3. Disconnect vacuum hoses from booster check valve (1).
4. Remove the brake lines (4) from the master cylinder and the HCU (ABS vehicles only) or the junction block for clearance.
5. Disconnect the HCU from the mounts and move to the side for clearance of the booster.




6. Remove knee blocker under the steering column.
7. Remove the brake light switch and discard.
8. Remove retaining clip (3) that secures booster push rod to brake pedal (2).
9. Remove nuts attaching booster (1) to the dash panel.
10. In engine compartment, slide booster studs out of dash panel, tilt booster upward, and remove booster from engine compartment.