Removal

BULB - SIDE MARKER

NOTE: The following procedure applies only to vehicles manufactured for domestic markets. Vehicles manufactured for export markets do not have a bulb, socket or wiring provided to illuminate the front side marker compartment of the front lamp unit. The front side marker lens is present, but serves only as a reflector on export market vehicles.





1. Disconnect and isolate the battery negative cable.

2. Partially remove the grille and both front lamp units from the face of the front end module as a unit.

3. Disconnect the wire harness connector (2) from the connector receptacle integral to the side marker bulb socket on the back of the front lamp unit housing (3) located on the back of the front end module grille (5).

4. Firmly grasp the front side marker bulb socket on the back of the housing and rotate it counterclockwise about 30 degrees to unlock it.

5. Pull the socket and bulb straight out from the keyed opening in the housing.

6. Pull the base of the bulb straight out of the socket.