Part 3

ASSEMBLY - Part 3


100. Install the new o-ring (1) onto the output speed sensor.




CAUTION: Be sure to install the select shim between the secondary speed sensor and the converter housing before installing the secondary speed sensor.

101. Install the output speed sensor (1) into the converter housing. Install and tighten the mounting bolt to 6 Nm (52 in lbs.).




CAUTION: Apply CVT fluid on the seal part when installing the CVT fluid filter.

102. Install the CVT fluid filter (1) into the transaxle case.




CAUTION: Do not re-use the o-ring. Apply CVT fluid when installing the o-ring.

103. Install the new o-ring (1) onto the CVT fluid filter.




104. Install the CVT fluid cooler (1) onto the transaxle case. Install and tighten the mounting bolts to 4 Nm (37 in.lbs.).




105. Remove the Transmission Service Stand 9878 (1) from the Belt side of the transmission case.




NOTE: Gauge Bar 6311 can be used for doing the following measurement.

NOTE: When conducting measurements, measure two or more places and calculate the average value.

106. Install the torque converter on the transaxle and measure the dimension (1) to see if it is at least 13 mm. If the measurement is less than 13 mm, the torque converter is not fully installed.

NOTE: Use the designated brand of CVT fluid. Use of other brands of CVT fluid other than the designated brand will deteriorate the driveability and the durability of the CVT, and will cause damage to the CVT.

107. Fill the transaxle with CVT fluid. Transmission Fill.