Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2009 >> Dakota 4WD V8-4.7L >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Electronic Brake Control Module >> Service and Repair >> Removal and Replacement >> Anti-Lock Brake System Module - Removal
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Anti-Lock Brake System Module - Removal






REMOVAL

CAUTION: When removing ABM from HCU, be sure to completely separate the two components (approximately 38 mm (1.5 in.) before removing ABM. Otherwise, damage to the pressure sensor or Pump Motor connection may result requiring HCU replacement. Do not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and issues in the future.

NOTE: If the ABM needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new ABM. For axle type refer to Differential and Driveline. For tire revolutions per mile,Specifications . To program the ABM refer to the Appropriate Diagnostic Service Information.





1. Disconnect the pump electrical connector (3) from the HCU (2).
2. Remove the module mounting screws (1).





3. Remove the module (1) from the HCU (2).

pro multis · About Operation CHARM