B. Reprogram the ORC Module

NOTE:
The Occupant Restraint Controller (ORC) module is "abort - recovery" supported. If this flash process is interrupted/aborted repeat the procedure.

NOTE:
The wiTECH software must be at level 11.02 or later to perform this service procedure.

1. Select "ORC" from the vehicle view screen.

2. Select the "FLASH" tab.

3. Select the flash file from the list.

4. Select the "UPDATE ORC" button and follow the screen prompts.

NOTE:
If the flash was interrupted or failed, repeat the reprogramming procedure.

5. Clear all DTC's.

NOTE:
Due to the ORC programming procedure, DTC(s) may be set in other modules (PCM, TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle, if so equipped. Some DTC's may cause the MIL to illuminate.

6. Place the ignition in the "OFF" position, remove the wiPOD from the data link connector and disconnect the battery charger.

7. Close the hood and return the vehicle to the customer.