Rear Suspension Knuckle - Installation

INSTALLATION

1. If necessary, install the hub/bearing in the knuckle Rear Hub And Bearing - Installation.





2. Position the knuckle/ball joint into the control arm and with the knuckle tilted out, install the ball joint nut (1) and torque to 205 Nm (151 ft. lbs.).
3. Install the spring Rear Suspension Coil Spring(s) - Installation.
4. Remove the support from the lower control arm.

NOTE: Make sure the park brake cable seats properly.

5. Push the park brake cable into the knuckle and seat.
6. Install the park brake shoes Installation.
7. Install the wheel Service and Repair.

8. Remove the supports and lower the vehicle.