Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2012 >> Caliber L4-2.4L >> Repair and Diagnosis >> Cruise Control >> Cruise Control Switch >> Service and Repair >> Speed Control Switch - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Speed Control Switch - Installation






INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the speed control switch (3) to the steering wheel.
2. Install and tighten the three screws (2 and 4) that secure the speed control switch to the steering wheel armature. Tighten the screws to 1.6 Nm (15 in. lbs.).
3. Reconnect the steering wheel wire harness connector (1) to the speed control switch connector receptacle.
4. Reinstall the horn switch into the steering wheel. Horn Switch - Installation.
5. Reconnect the battery negative cable.

pro multis · About Operation CHARM