Mid

MID

Special Tools:










1. Disconnect the negative battery cable.
2. Remove the instrument cluster bezel retainer (1) and remove the bezel (2).Instrument Cluster Bezel - Removal.





3. Disconnect the harness connectors (2 & 3) from the rear of the Integrated Center Stack (ICS) screen module (1) to allow better access to the 40 - way connector.

CAUTION: Push the 40 way connector in before pushing on the locking clip. Failure to follow these instructions will damage or break the connector locking clip.






NOTE: In the event that the locking tab breaks or is broken, do not replace the harness. The connector will still lock and the harness will still function as designed.

CAUTION: Never pull the connector out by the wires. Failure to follow these instructions will damage or break the wires and/or connector.

4. Push in on the 40 - way connector (1).





5. Gently push down on the connector release lock (1).





6. Using a pocket screw driver or a trim stick or equivalent (1), gently pry on one side of the connector (2).





7. Using a pocket screw driver or a trim stick or equivalent (1), gently pry on the other side of the connector (2).
8. Use steps 7 and 8 until the connector is out far enough to grab the connectors with your fingers.





9. Remove the retainers (1) and remove the (ICS) screen module (2) from the instrument panel bezel.