Blind Spot Module - Description

DESCRIPTION





Blind Spot Module: Vehicles equipped with the Blind Spot Monitor (BSM) system, includes a module that is secured to a mounting bracket within the right inner quarter panel. Concealed beneath the inner quarter trim panel, the module is secured to the mounting bracket by two push-pin type retainers.

Hard-wired circuitry connects the various blind spot monitor system components to each other through the vehicle electrical system. These hard-wired circuits are integral to several wire harnesses, which are routed throughout the vehicle, and retained by many different methods. These circuits may be connected to each other, and to the vehicle electrical system through the use of a combination of soldered splices, splice block connectors, and many different types of wire harness terminal connectors and insulators. Refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and connector repair procedures, further details on wire harness routing and retention, as well as pin-out, and location views for the various wire harness connectors, splices and grounds.

The Blind Spot Monitor system components cannot be adjusted or repaired. If any of the BSM system components are damaged or inoperative, that component must be replaced. For more information on the blind spot monitor system and its components Blind Spot Monitoring System - Description