Installation

INSTALLATION





1. Install front axle assembly (1)(Figure 1) into position. Install and tighten axle housing-to-engine bolts to 65 Nm (48 ft. lbs.).





2. Install power steering return line to cradle by fastening clips (1).





3. Install axle assembly support bracket (1)(Figure 3) and torque bolts to 28 Nm (21 ft. lbs.).

4. Install RH catalytic converter/exhaust pipe assembly.Catalytic Converter - Installation
5. Install front propeller shaft.Propeller Shaft - Installation
6. Install intermediate shaft.Half Shaft - Removal
7. Install both front halfshafts.Half Shaft - Installation





8. Fill axle with 600ml (0.64 qts.) of Mopar(R) 75W-90 Synthetic Gear Lubricant. Fluid level should be at or near bottom of fill hole. Torque fill plug (1)(Figure 4) to 30 Nm (22 ft. lbs.).
9. Lower vehicle.