Park Assist Module - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Remove the trim from the right quarter inner panel (2) to access the park assist module (1), which is located to the rear of the C-pillar and above the right rear wheel housing. Quarter Trim Panel - Removal.
3. If equipped, remove the passive entry antenna to access the park assist module fastener.
4. Disconnect the two body wire harness connectors (3) from the park assist module connector receptacles.
5. Remove the plastic push-in fastener (4) that secures the module to the right quarter inner panel.
6. Slide the module upward far enough to disengage the two lower mounting tabs from the stamped pockets in the right quarter inner panel.
7. Remove the module from the vehicle.