Front Lamp Unit - Installation

LAMP






NOTE: If the front lamp is being replaced with a new unit, the bulbs and sockets must be transferred from the unit being replaced.

1. Position the front lamp unit to the front of the vehicle.
2. Reconnect the headlamp and dash wire harness connectors to the back of the lamp housing.
3. Position the front lamp unit into the Front End Module (FEM).
4. Flex the fascia and grille (1) outward far enough to install and tighten the three screws (2) that secure the front lamp unit to the FEM. Tighten the screws securely.
5. Reinstall the four plastic push-pin fasteners that secure the upper grille to the FEM.
6. Reinstall the front fascia on the same side of the vehicle as the front lamp unit being installed. Front Bumper Fascia - Installation
7. Reconnect the battery negative cable.
8. Confirm proper headlamp alignment. Adjustments.