Installation

INSTALLATION





The picture displays a typical EVAP Canister and a typical ESIM switch. After installing any ESIM switch, the electrical connector on the switch must be in the 3 O'clock position. This step must be done for proper ESIM switch operation.

1. The fresh air hose that attaches to the ESIM must have a clear opening to the atmosphere. Check the fresh air hose, including the fresh air filter, for obstructions or restrictions at the ESIM. If a restriction is present, the system will not allow free flow passage of clean air, and an early shut off of the fuel fill nozzle may occur during fuel fill.
2. Be sure O-ring (2) and EVAP canister opening are clean.
3. Install ESIM (1) to the EVAP canister (3).





4. Install fresh air hose (2) and electrical connector (3) to the ESIM.










5. Install the spare tire well (2) with 4 nuts (1).
6. Lower vehicle.
7. Install the spare tire.
8. Connect negative battery cable, tighten nut to 5 Nm (45 in. lbs.).