Washer Fluid Level Switch - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Remove the washer reservoir from the back of the cooling module on the Front End Module (FEM). Windshield Washer Reservoir - Removal.
3. Disconnect the FEM wire harness connector from the washer fluid level switch connector receptacle (3) on the back of the reservoir.
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the barbed nipple of the washer fluid level switch out of the rubber grommet seal in the washer reservoir. Care must be taken not to damage the reservoir.
5. Remove the switch from the washer reservoir.
6. Remove the rubber grommet seal from the switch mounting hole in the washer reservoir and discard.