A/C And Heater Control - Installation

INSTALLATION





1. Position the rear A/C-heater control (3) to the rear control bezel (1) and align the control to the two plastic guide posts on the back of the bezel.
2. Install the two screws (4) that secure the rear A/C-heater control to the rear control bezel. Tighten the screws to 1.2 Nm (10 in. lbs.).
3. Connect the wire harness connector to the back of the rear A/C-heater control and install the bezel and control as an assembly to the headliner. Make sure the four metal retaining tabs (2) are fully engaged.
4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool HVAC Verification Test.