Maintenance Required Lamp/Indicator: Service and Repair

RESET PERFORM SERVICE INDICATOR

The Perform Service message will display on the Electronic Vehicle Information Center (EVIC) each time you turn the ignition switch to the ON/RUN position to indicate that emission system scheduled maintenance is required. After performing the scheduled maintenance, reset the Perform Service indicator using the following procedure:

1. Turn the ignition switch to the ON position, but do not start the engine.
2. Depress and release the brake pedal two times.
3. Fully depress and release the accelerator pedal slowly two times within 10 seconds.
4. Turn the ignition switch to the OFF/LOCK position.

NOTE: If the indicator message illuminates when you start the engine, the Perform Service indicator did not reset. If necessary, repeat this procedure.