Installation

INSTALLATION




1. Install the hub/bearing assembly to the vehicle.
2. Install the three mounting bolts (1) for the hub/bearing. Tighten the bolt to 130 Nm (96 ft.lbs.).
3. Install the axle shaft nut. Tighten the nut to 135 Nm (100 ft.lbs.). (if equipped with four wheel drive)
4. Install the wheel speed sensor to the hub. Tighten the bolt to 13.5 Nm (10 ft.lbs.).
5. Install the disc brake rotor.
6. Install the disc brake caliper adapter. Tighten the nut to 135 Nm (100 ft.lbs.).
7. Install the tire and wheel assembly.