B127F

B127F-PTS SENSOR 11 RING TIME TOO LONG

For a complete wiring diagram, refer to the Wiring Information.

NOTE: The numbering system for the park assist sensors allows for up to twelve sensors on the vehicle, six front and six rear. The sensors are numbered in a clockwise manner starting at the left front bumper. The left front sensor (if equipped with front park assist) is the number 1 sensor. The numbering continues in a clockwise direction around the vehicle. Since Chrysler Group vehicles use only four rear sensors, sensor numbers 7 and 12 are omitted, so the left rear sensor is the number 11 sensor.

- When Monitored:
While the vehicle is in reverse for speeds less than 16km/h (10 mph).

- Set Condition:
Data line stuck at 0.





1. CHECK FOR ACTIVE DTC

NOTE: Before proceeding with this diagnostic procedure, remove any ice, snow, mud, dirt, or other obstructions from the front/rear fascia.

1. Turn the ignition on.
2. Using the scan tool, read Park Assist Module DTCs.

Is this DTC active?

Yes

- Go To 2

No

- The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. REPLACE PARK ASSIST SENSOR NO. 11

View Repair

Repair

- Replace Park Assist Sensor No. 11.
- Perform the BODY VERIFICATION TEST. Body Verification Test.