B1855

B1855-DRIVER WINDOW MOTOR CONTROL CIRCUIT HIGH





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Whenever the module is awake.

- Set Condition:
When both Driver Window Driver circuits (Up and Down) are supplied with voltage during a window movement command for more than five ms., this code will set.





1. TEST FOR INTERMITTENT CONDITION

NOTE: This test shows text for a Left Hand Drive (LHD) vehicle. Right Hand Drive (RHD) vehicles use the same cavities. Refer to the schematic for difference names and circuit numbers.

1. Turn the ignition on.
2. With the scan tool, record and erase the DTCs
3. Try to operate the Driver Window up and down several times.
4. Wait 30 seconds.
5. With the scan tool, read the DTCs.

Does the scan tool display B1855-DRIVER WINDOW MOTOR CONTROL CIRCUIT HIGH?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. WINDOW MOTOR SHORTED




1. With the scan tool, erase the DTCs.
2. Turn the ignition off.
3. Disconnect the Driver Window Motor connector.
4. Turn the ignition on.
5. Operate the driver window switch up and down several times.
6. With the scan tool, read the DTCs.

Does the scan tool display B1855-DRIVER WINDOW MOTOR CONTROL CIRCUIT HIGH?

No

- Replace the Driver Window Motor (regulator).
- Perform the BODY VERIFICATION TEST. Body Verification Test.

Yes

- Go To 3

3. (Q321) LEFT FRONT WINDOW EXPRESS DOWN DRIVER CIRCUIT SHORT TO VOLTAGE




1. Turn the ignition off.
2. Disconnect the Driver Door Module C4 connector.
3. Turn the ignition on.
4. Measure the voltage between the (Q321) Left Front Window Express Down Driver circuit and Ground.

Is there any voltage present?

Yes

- Repair the (Q321) Left Front Window Express Down Driver circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 4

4. (Q311) LEFT FRONT WINDOW EXPRESS UP DRIVER CIRCUIT SHORT TO VOLTAGE




1. Measure the voltage between the (Q311) Left Front Window Express Up Driver circuit and Ground.

Is there any voltage present?

Yes

- Repair the (Q311) Left Front Window Express Up Driver circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Driver Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.