SATC Continuity Chart

S.A.T.C. Continuity Test (Part 1 of 2). Rear wheel drive cars:

Fig. 6 S.A.T.C. wiring harness test points. Rear wheel drive cars:

Part 1 of 2




The glove compartment and righthand cowl trim panel must be removed before performing the continuity test. Check to ensure at least 11 volts is available at test points shown. Before testing system for continuity, disconnect power feed connector and in-car sensor. Refer to S.A.T.C Continuity Tests for procedures.

S.A.T.C. Continuity Test (Part 2 of 2). Rear wheel drive cars:

Part 2 of 2