Front

INSTALLATION





1. Install the wheel speed sensor head (2) into the knuckle. Install the mounting screw (1) and tighten it to 7 Nm (62 in. lbs.).
2. Install the routing clip securing the wheel speed sensor cable to the knuckle.






CAUTION: Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an open circuit. Be sure that cables are installed, routed, and clipped properly.

3. Route the wheel speed sensor cable as shown and clip into location (1, 2, & 3).





4. Route the wheel speed sensor cable as shown and clip into location (2, 3).
5. Connect wheel speed sensor cable (1) to wiring harness.
6. Lower the vehicle.
7. Perform the Diagnostic Verification Test and clear any faults Service and Repair.