Communications Control Module: Testing and Inspection

PROGRAM THE CTM (Convergence Telematics Module)
When replacing any module not the replacement and programming order. For more information see the MODULE REPLACEMENT AND PROGRAMMING ORDER GUIDE in Programming and Relearning.
After verifying the proper replacement and programming order, follow the steps below to program the CTM.

1. Connect the scan tool.
2. Check vehicle for DTCs.
3. Clear all stored DTCs.
4. Turn car OFF then ON and confirm DTCs are gone.
5. Go to CTM >> Misc. Functions >> Proxi Alignment

If required, continue to programming the next module.