Disassembly

FIG. 3 Front Driveshaft-Exploded View:

FIG. 4 Clamp Removal:

1. With the front driveshaft assembly on a bench, cut the boot clamps with sidecutters (Fig. 4). Remove and discard the clamps.

2. Separate the rear slip yoke from the splined stub shaft on the driveshaft.

3. Remove the rubber boot. Inspect the boot for rips or tears and replace if required.

FIG. 5 Inspecting Grease for Contamination:

If during inspection, the driveshaft boot is found to be cracked or split, the grease should be checked for contamination (Fig. 5). If driveshaft was operating satisfactorily and the grease does not appear to be contaminated, add grease as described in the assembly portion of this procedure and replace the boot. If the grease appears contaminated, disassemble the driveshaft and inspect the stub shaft and slip yoke for wear.

4. If required, remove and install the U-joints as described under Snap Ring Type U-Joint in the Disassembly and Assembly portion of Driveshaft-Single Type U-Joint.