X84 - Check FPM Circuit Continuity

- Key "OFF".

- Disconnect Powertrain Control Module (PCM). Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.

- Install breakout box, leave PCM disconnected.

- Disconnect Constant Control Relay Module (CCRM).

- Measure resistance between test pin 8 at the breakout box and Pin 5 at the CCRM vehicle harness connector.

- Is resistance less than 5.0 ohms?

Yes -- Go to X86 X86 - Check Front/Left HO2S For Short to Power

No -- Service open circuit. Remove breakout box. Reconnect all components. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)