Quick Test Procedures

1. Record and then erase Quick Test codes.

2. Warm engine to normal operating temperature.

3. Make sure transmission fluid level is correct.

4. With transmission in OVERDRIVE, press Transmission Control Switch (TCS)(LED lamp should illuminate) and moderately accelerate from stop to 40 mph (64 km/h). This allows transmission to shift into third gear. Hold speed and throttle opening steady for a minimum of 30 seconds.

5. Press TCS (LED lamp should turn off) and accelerate from 40 mph (64 km/h) to 50 mph (80 km/h). This allows transmission to shift into fourth gear. Hold speed and throttle position steady for a minimum of 30 seconds.

6. With transmission in fourth gear and maintaining steady speed and throttle opening, lightly apply and release brake pedal (to operate stoplamps). Then hold speed and throttle steady for an additional five seconds (minimum).

7. Brake to a stop and remain stopped for a minimum of 20 seconds.

8. Repeat Steps 4 through 6 at least five times.

9. Perform Powertrain Quick Test and record continuous codes.