Air Bag Warnings and Safety Instructions

WARNING: Service is made by replacement only.

Do not attempt service of:
- Crash Sensors
- Air Bag Sliding Contact
- Air Bag Diagnostic Monitor
- Air Bag Modules
- Air Bag Modules with discolored or damaged cover deployment doors must be replaced, not repainted.

Never probe the connectors on the air bag. Doing so may result in air bag deployment which could result in personal injury.

All component replacements and wiring service must be made with the positive battery cable disconnected for a minimum of one minute before service or replacement is attempted.

Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag system is involved in a crash where the fenders or grille area have been damaged, inspect the air bag sensor mounting brackets for deformation. If damaged, the sensor should be replaced whether or not the air bag is deployed. In addition, ensure that body structure in the area of sensor mounting is restored to its original condition.

NOTE:

- If a part is replaced and the new part did not correct the condition, reinstall the original part and perform the diagnostic procedure again.

- The instruction "disconnect" always refers to a connector. Never detach a component from the vehicle when instructed to "disconnect."