Autolock

All doors will automatically lock each time the vehicle is driven after the following steps are completed:
^ The ignition switch is in the RUN/ACC position and the autolock feature is enabled.
^ The shift control selector is passed into and out of the REVERSE position.
^ All doors are closed when the driver releases the brake pedal.

After the initial lock, all doors will automatically relock when any door is opened and then closed followed by the release of the brake pedal. However, the doors will not relock if the ignition switch is in the OFF position.

The door may not automatically lock if:
^ The vehicle is shifted quickly into gear after starting the engine.

Enabling and Disabling
The enable/disable mode allows the autolock feature to be turned off and on.

The enable/disable mode is entered when the following series of steps is performed:
1. Close all of the doors.
2. Confirm that the ignition switch is in the OFF position.

NOTE: Steps 3 through 7 must be performed within 30 seconds.

3. Turn the ignition switch from OFF to RUN.
4. Press the power door lock UNLOCK button three times.
5. Turn the ignition switch from RUN to OFF.
6. Press the power door lock UNLOCK button three times.
7. Turn the ignition switch from OFF to RUN.
8. Verify that the RAP module chirps the horn. This indicates that the RAP module is now in the enable/disable mode and ready to accept program changes.
9. Press the power door lock UNLOCK button one time to command the RAP module to toggle the autolock/relock feature OFF.
10. Press the power door lock LOCK button once to enter the command.
11. Verify that the vehicle horn chirps one time to signal the RAP module confirmation of the command. There should only be one chirp indicating that autolock/relock feature has been disabled. If one chirp is heard, followed by a longer honk, the autolock/relock feature has just been enabled. Return to step 9.
12. Turn the ignition switch to the OFF position to exit the enable/disable mode.
13. Verify that the RAP module chirps the horn once to indicate that a feature has been changed and that autolock/relock has been disabled.

The autolock feature is turned on at the factory. The RAP module returns to the prior setting any time battery power is interrupted.