Driveshaft Angle Inspection - Protractor Method
1. Raise and support the vehicle.- Normalize the suspension.
NOTE: Use a drive-on hoist or back onto a front end alignment rack.
2. With the vehicle empty and all fluids full, measure where indicated and verify that the curb position ride height angle is within specification.
- If out of specification, inspect the suspension and chassis.
Curb Position Ride Height Angle
Base Suspension: 1.05°
Air Suspension: 0.31°
3. Place the (A) protractor flush against the (B) drive shaft.
4. Record the reading and subtract the curb position ride height angle to obtain the corrected driveshaft angle.