Rear

REMOVAL





1. Disconnect the battery ground cable.





2. Remove the rear brake anti-lock sensor.
1 Disconnect the electrical connector.
2 Remove the bolt.
3 Remove the rear brake anti-lock sensor.

CAUTION: Clean off dirt and debris that may have collected around the rear brake anti-lock sensor before removal to prevent fluid contamination.

INSTALLATION





1. Clean and inspect the rear brake anti-lock sensor.
1 Clean the axle mounting surface.
2 Inspect and clean the magnetized rear brake anti-lock sensor pole piece.
3 Inspect the rear anti-lock brake control o-ring for damage. Replace if necessary.
4 Lightly lubricate the rear anti-lock brake control o-ring with Motorcraft Synthetic Rear Axle Lubricant F1TZ-19580-B or equivalent meeting Ford specification WSL-M2C192-A.

CAUTION: Use care not to get dirt in the rear axle housing.





2. Install the rear brake anti-lock sensor.
1 Position the rear brake anti-lock sensor and install the rear brake anti-lock sensor bolt.

NOTE: Do not apply force to the plastic rear brake anti-lock sensor connector.

2 Connect the electrical connector.





3. Connect the battery ground cable.

NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.