1990-97 F-250 HD/F-350/Bronco Frnt./Rear Bumper
1990-97 F-250 HD/F-350/BRONCO - FRONT BUMPER1. Hoist vehicle until bumper is at working level.
2. Remove the lower valance out of the way to allow access to inside of front bumper.
3. Clean excessive dirt from inside and outside the bumper.
4. Tape license plate bolt holes.
5. Spray the edge of the opening and the bolt opening area including the license plate lights bracket holes with Super Seal Anti-Corrosion Compound.
6. Reinstall lower valance.
7. Remove protective tape.
8. Lower vehicle.
9. Clean off overspray as needed.
1990-97 F-250 HD/F-350/BRONCO - REAR BUMPER
1. Install newspaper between the tailgate and the bumper top cover to prevent spray on the tailgate.
2. Hoist vehicle until bumper is at working level.
3. Clean excessive dirt from inside and outside the bumper.
4. Spray the back side of the bumper from underneath the vehicle. Make sure to spray the license plate light opening, and the bolt mounting areas above the bumper mounting bracket to prevent water from leaking to the front from the back side. Also spray the bumper pad retaining holes.
5. Lower vehicle.
6. Remove paper and clean off overspray as needed.