Seat - Rear, Quad Bucket

Seat - Rear, Quad Bucket

SPECIAL TOOL(S)

Safety Belt Bolt Bit:

Disassembly

1. Remove the rear quad bucket seat from the vehicle. For additional information, Procedures

2.NOTE: If the same armrest is being installed, the armrest plate and bolt can be reused, but install a new crown washer when installing the armrest.

Remove the armrest.
1. Pull back the Velcro� fastened armrest cover to expose the armrest bolt.
2. Remove the bolt and the crown washer.
3. Remove the armrest.






3. Remove the safety belt buckle end assembly.
1 Use the Safety Belt Bolt Torx Bit to remove the buckle end bolt.
2 Remove the safety belt buckle end.







4. Remove the detachable safety belt anchor buckle end.
1 Use the Safety Belt Bolt Torx Bit to remove the detachable safety belt anchor buckle end bolt.
2 Remove the detachable safety belt anchor buckle end.







5. Remove the right-hand seat side trim.
1 Remove the screws (one located behind the seat back latch).
2 Remove the right-hand seat side trim.







6. Remove the left-hand seat side trim.
1 Remove the screws.
2 Remove the left-hand seat side trim.







7. Remove the bolts.







8. Remove the bolt.







9. Remove the seat back.







10. Remove the seat back cover.
1 Unlatch the C-clip at the bottom of the seat back.
2 Slide the cover upward over the seat back, disengaging the Velcro(R) fasteners (not shown), and remove the seat back cover.

11. Remove the seat back cushion.







12. Remove the seat back latch.
1 Remove the bolt.
2 Remove the seat back latch.







13. Remove the seat support.
1 Remove the four seat support nuts.
^ Two nuts are shown in the illustration; the other two nuts are similar.
2 Remove the seat support.







14. Remove the seat track bolts and remove the seat track assembly.

NOTE: On the RH side seat only, make sure the seat track is in the full rearward position to access the front seat track bolts.

15. On the LH side seat only, remove the two bolts from both spacer brackets and remove both spacer bracket assemblies.







16. Remove the seat cushion cover.
1 Unlatch the J-clips on all four sides of the seat cushion cover.
2 Remove the seat cushion frame from the seat cushion.
3 Remove the seat cushion cover from the seat cushion, disengaging the Velcro(R) fasteners (not shown).

17. Remove the seat cushion from the seat frame.

ASSEMBLY







1. Follow the disassembly procedure in reverse order. Tighten the fasteners to the correct specifications.







2. Check the restraint system for correct operation.