Power Steering Pump

Special Tools:

Removal
1. Remove the drive belt.
2. Raise and support the vehicle.





3. Disconnect the power steering reservoir pump hose from the power steering pump.
- Drain the power steering oil reservoir





4. Disconnect the high-pressure fitting from the power steering pump.





5. Remove the two top power steering pump bolts.





6. Remove the lower pump bolt and remove the power steering pump.

Installation
1. Position the power steering pump and loosely install the three bolts.





2. Tighten the two upper power steering pump bolts.





3. Tighten the lower power steering pump bolt.





4. Install a new power steering seal on the power steering pressure fitting by stretching the seal over the seal replacer until it is large enough to slip over the threads of the fitting.





5. Connect the power steering pressure fitting to the power steering pump.





6. Install the power steering reservoir pump hose to the power steering pump.
7. Lower the vehicle.
8. Install the drive belt.
9. Fill, purge and leak check the system.