Key-In-Ignition Warning Switch

REMOVAL
1. To replace the brush assembly, refer to Cruise Control.







2. Remove the ignition switch lock cylinder.
1 Insert the ignition key and turn to the RUN position.
2 Insert a punch in the access hole of the steering column and press the release tab while pulling out the ignition switch lock cylinder.







3. Remove the key-in-ignition warning switch.
1 Pry the clip downward.
2 Release the key-in-ignition warning switch from the rear of the ignition switch lock cylinder.

INSTALLATION







1. To install, reverse the removal procedure. Verify the ignition switch lock cylinder operation.