20 Percent
REAR SEAT BACKREST - SECOND ROW, 20 PERCENTREMOVAL
1. Remove the 20 percent seat from the vehicle.
2. Remove the two screws (one shown) from inside of the right side shield.
3. Release the pin-type retainer and remove the side shields.
4. Remove the two screws (one shown) from inside of the left side shield.
5. Release the pin-type retainer and remove the side shields.
6. Remove the left hinge side shield screw and remove the side shield.
7. Unsnap the recliner pull strap handle and pull the handle through the seat.
8. Note the location and routing of the recliner cable for installation. The cable needs to be routed in front of the crosstube.
9. Pinch the tabs on the recliner cable end and release the cable from the retainer.
10. Remove the safety belt anchor bolt.
11. Release the J-clips.
12. Remove the two pin-type retainers and remove the panel.
13. Remove the screw from the seat backrest support panel and release the J-clips under seat backrest support panel.
14. Invert the seat backrest cover up to expose the inner swivel bolts and remove the swivel bolts.
15. Remove the left-side pivot bolt.
16. Remove the right-side bolts.
17. Remove the seat backrest.
INSTALLATION
1. To install, reverse the removal procedure.