Second Row, 40 Percent

REAR SEAT - SECOND ROW, 40 PERCENT

REMOVAL







1. Remove the two seat-to-floor bolt covers.







2. Remove the front seat-to-floor bolts.
3. Fold the seat up to the E-Z entry position.







4. Remove the rear seat-to-floor bolts.
5. Remove the 40 percent seat from the vehicle.

INSTALLATION
1. Install the seat in the vehicle.
2. Install both locator pins into the locator holes in the floor pan.
3. Latch the rear latches to strikers.







4. Install the front outboard seat-to-floor bolt and then the inboard seat-to-floor bolt.
5. Fold the seat up into E-Z entry position.







6. Install the rear seat-to-floor bolts.







7. NOTE: Make sure the seat latches when allowed to free fall from the E-Z entry position (if the seat does not completely latch after free fall, raise the seat back. The seat must latch prior to the seat backrest locking in the upright position).

Install the two second row seat-to-floor bolt covers.

8. Check the active restraint system for correct operation.