Evaporative Emission System Leak Test

Evaporative Emission System Leak Test

Special Tool(s):

SPECIAL TOOL(S)

CAUTION: The evaporative emission system must not be pressurized to more than 3.48 kPa (14 inches H2O) or damage to the evaporative emission system may occur.

1. Connect the Evaporative Emission System Leak Tester to the evaporative emission test port.
2. Close the canister vent solenoid.
3. Pressurize the evaporative emission system to 3.48 kPa (14 inches H2O).
4. Monitor the system for two minutes. The system fails the leak test if the pressure falls below 2.0 kPa (8 inches H2O).
5. Repair any leaks as necessary.
6. Repeat the leak test until the system remains above 2.0 kPa (8 inches H2O) after the two-minute test period.