Diagnostic Instructions

DIAGNOSTIC INSTRUCTIONS - AIR BAG AND SAFETY BELT PRETENSIONER SUPPLEMENTAL RESTRAINT SYSTEM (SRS)

Special Service Tool(s):

SPECIAL TOOL(S)

The symptom chart can be used to help locate supplemental restraint system (SRS) concerns if no diagnostic trouble codes (DTCs) are retrieved and the listed symptoms are observed. Whether or not the listed symptoms are observed, always carry out the following:
1. Retrieve all DTCs stored in the restraints control module (RCM) memory.
2. Run the On-Demand Self Test to determine what DTCs are currently being sensed by the RCM. Refer to On-Demand Self Test. On-Demand Self Test
3. If the stored DTCs are different than the current DTCs, always repair the current DTCs first.
4. If memory displays different continuous DTCs than the On-Demand Self Test, carry out in the following order:
- On-Demand Self Test
- Memory (Retrieve/Clear Continuous DTCs)

A DTC can indicate several concerns. The DTCs are to assist in system diagnosis and are not to be considered definitive. Always refer to the pinpoint test corresponding to the DTC to determine where the concern lies and to repair the concern correctly.

The SRS diagnostics can be divided into three sections:
- diagnostic test modes
- PID/data monitor and record
- active command modes

Diagnostic Test Modes
Two menu options are available under the diagnostic test modes:
- Retrieve/Clear Continuous DTCs
- On-Demand Self Test.