Multifunction Switch
Removal and Installation1. Remove the steering wheel.
2. NOTE: Lower tilt release handle to access the second screw.
Remove the lower steering column shroud.
^ Remove the screws.
3. NOTE: The screw is located behind the multifunction switch.
Remove the screw and the upper steering column shroud.
4. Remove the bolt, push the release and raise the switch.
5. NOTE: A small screwdriver will be required to depress the connector release tab on connector number 2.
Remove the multifunction switch.
^ Disconnect the connectors in the sequence shown.
^ Remove the switch.
6. To install, reverse the removal procedure.