Front

Removal and Installation

WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the LH rear quarter trim panel. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.

1. If equipped, turn the air suspension switch to the OFF position.





2. Disconnect the wheel speed sensor connector.
3. Remove the wheel and tire assembly.





4. Remove the bolt and detach the retainers





5. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can result.

Remove the bolts, and position the caliper, pads and anchor place aside





6. Remove the brake disc.





7. Remove the bolts and the wheel bearing and hub assembly.

8. CAUTION: If the original wheel bearing and hub is being reinstalled, make sure to install a new O-ring.

To install, reverse the removal procedure.