Fluid Leakage In Torque Converter Area

Fluid Leakage in Torque Converter Area





In diagnosing and correcting fluid leaks in the front pump assembly and torque converter area. use the following procedures to locate the exact cause of the leakage. Leakage at the front of transmission, as evidenced by fluid around the torque converter housing, may have several sources. By careful observation it is possible, in many instances, to pinpoint the source of leak before removing the transmission the vehicle. The paths which the fluid takes to reach the bottom of the torque converter housing are shown in the illustration. The following five steps correspond with the numbers in the illustration.
1. Fluid leaking by the front pump seal lip will tend to move along the impeller hub and onto the back of the impeller housing. Except in the case of a total seal failure, fluid leakage by the lip of the seal will be deposited on the inside of the torque converter housing only, near the outside diameter of the housing.
2. Fluid leakage by the outside diameter of the front pump seal and front pump body will follow the same path that leaks by the inside diameter of the front pump seal follow.
3. Fluid leakage from the converter drain plug, converter seal weld or converter-to-flexplate stud weld will appear at the outside diameter of the torque converter, on the back face of the flexplate, and in the converter housing only near the flexplate. Fluid leaks from the torque converter will leave a ring of fluid around the inside of the torque converter housing.
4. Fluid that leaks by a front pump to case bolt or pump gasket will be deposited on the inside of the torque converter housing only. Fluid will not be deposited on the back of the torque converter.

5. NOTE: White facial tissue may aid in determining the color (red is transmission fluid) and source of the leaking fluid.

Engine oil leaks are sometimes incorrectly diagnosed as transmission pump gasket leaks. The following areas of possible leakage should also be checked to determine if engine oil leakage is causing the concern.
^ Leakage at the valve cover gasket may allow oil to flow over the torque converter housing or seep down between the torque converter housing and cylinder block. causing oil to be present in or at the bottom of the torque converter housing.
^ Oil galley plug leaks will allow oil to flow down the rear face of the cylinder block to the bottom of the torque converter housing.
^ Leakage at the crankshaft rear oil seal will work back to the flexplate, and then into the torque converter housing.
^ Leakage at oil pressure sensor.