Diagnostic Strategy

Diagnostic Strategy

NOTE: Do not take short cuts or assume that critical checks or adjustments have already been made.

Troubleshooting an electronically controlled automatic transmission is simplified by using the proven method of diagnosis. One of the most important things to remember is that there is a definite procedure to follow.

Follow the procedures as written to avoid missing critical components or steps.

To diagnose a concern correctly, the technician should have the following available:
- Technical Service Bulletins (TSBs).
- Wiring Diagram.

These provide the information required when diagnosing transmission concerns.

Using the Diagnostic Flowchart as a guide, follow the steps as indicated.

Preliminary Inspection
- Know and understand the customer's concern.
- Check the fluid level and condition.
- Verify the concern by operating the vehicle.
- Check for non-factory add-on items.
- Check shift linkages for correct adjustment.
- Check TSBs for the concern.

Diagnostics
- Carry out on-board diagnostic procedures Key On/Engine Off (KOEO) and Key On/Engine Running (KOER).
- Record all Diagnostic Trouble Codes (DTCs).
- Repair all non-transmission codes first.
- Repair all transmission codes second.
- Erase all continuous codes and attempt to repeat them.
- Repair all continuous codes which reappear.
- If only pass codes are obtained, proceed to Diagnosis By Symptom for further information and diagnosis. 4R100

Follow the diagnostic sequence to diagnose and repair the concern the first time.