Low One-Way Clutch Assembly
Low One-Way Clutch AssemblyDisassembly
1. Inspect the low one-way clutch components:
1 Low one-way clutch inner race
2 Roller assemble
3 Low one-way clutch outer race
4 Outer race groove
5 Inner race groove
2. Position the low one-way clutch so the inner and outer race grooves are facing upward.
3. Remove the inner race.
4. Remove the roller assembly.
5. WARNING: Air pressure must not exceed 138 kPa (20 psi). Wear safety glasses when using compressed air. Failure to follow these instructions can result in personal injury.
Clean all parts thoroughly in clean solvent and blow dry with moisture-free regulated compressed air.
6. Inspect the low one-way clutch parts for damage and wear.
^ Outer race
^ Sprag assembly
^ Inner race
^ Lubrication holes
Assembly
1. NOTE: Outer tabs of the roller assembly must face up.
Install the roller assembly into the outer race with the groove facing up.
2. NOTE: To aid in inner race installation, rotate the inner race clockwise during installation.
Install the inner race with the grooves facing UP.
3. Check the operation of the one-way clutch as follows:
1 Hold the outer race.
2 Rotate the inner race clockwise. It should rotate with a slight drag without attempting to rotate the outer race.
3 Rotate the inner race counterclockwise. The inner race should rotate the outer race.