Safety Belt Buckle - Rear, SuperCab

SAFETY BELT BUCKLE - REAR, SUPERCAB

Removal and Installation

WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could increase the risk of injury in collisions.

NOTE: Safety belt buckles shown, safety belt and buckle similar.







1. From the bottom of the seat backrest, push the seat backrest upward, then pull the bottom outward and remove from the vehicle.







2. Remove the bolt and the safety belt buckles.
- To install, tighten to 55 Nm (41 lb-ft).

3. NOTE: Make sure the safety belt webbing is not twisted prior to installation.

To install, reverse the removal procedure.

4. Check the restraint system for correct operation.