Front

Stabilizer Bar

Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the 4 bolts and the 2 stabilizer bar brackets.
^ Discard the 4 bolts.
^ To install, tighten to 25 Nm (18 ft. lbs.)
3. Remove the stabilizer bar.
4. To install, reverse the removal procedure.