Rear Bumper: Service and Repair

BUMPER-REAR







Removal and Installation
1. Disconnect the license plate lamp electrical connectors.
2. If equipped, disconnect the trailer harness electrical connectors.







3. If equipped, detach the trailer harness pin-type retainer from the rear bumper.
4. If equipped, disconnect the rear parking aid electrical connector.

5. NOTE: Anytime the rear bumper nuts are removed, discard and install new rear bumper nuts.

Remove the rear bumper nuts.
- To install, tighten to 175 Nm (129 lb-ft).

6. Remove the rear bumper.
7. To install, reverse the removal procedure.
- Transfer components as necessary. If equipped with a rear parking aid sensor, refer to Collision Avoidance and Parking Assist Systems for additional information.