A/C Cycling Switch

A/C CYCLING SWITCH

The A/C cycling switch is mounted on a Schrader valve-type fitting on the side of the suction accumulator.
- A valve depressor, located inside the threaded end of the A/C cycling switch, presses in on the Schrader valve stem.
- This allows the suction pressure inside the suction accumulator to control the operation of the A/C cycling switch.
- The electrical switch contacts open when the suction pressure drops, the contacts close when the suction pressure rises. For specifications regarding operating pressure(s), Refer to Heating and Air Conditioning.
- When the A/C cycling switch contacts close, the A/C request signal circuit is completed to the PCM.
- When the A/C cycling switch contacts open, the A/C request signal circuit is interrupted and compressor operation stops.
- The A/C cycling switch will control the A/C evaporator core pressure at a point where the plate/fin surface temperature will be maintained slightly above freezing.
- This prevents icing of the A/C evaporator core and blockage of air flow.
- It is not necessary to discharge the refrigerant system to remove the A/C cycling switch.