Power Steering Pump

Power Steering Pump - 4.0L











Removal

CAUTION: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.

1. Using a suitable suction device, remove the power steering fluid from the reservoir.

2. With the vehicle in NEUTRAL, position it on a hoist.
3. Remove the power steering pump pulley.
4. Remove the pressure line bracket-to-engine bolt.
5. Remove the power steering pump supply hose bracket bolt.
6. Release the power steering pump supply hose clamp and disconnect the hose.
7. Disconnect the pressure line-to-pump fitting.
^ Remove and discard the Teflon(R) seal.
8. Remove the 3 bolts and the power steering pump.

Installation

1. NOTE: new Teflon(R) seal must be installed.

Using the special tool, install a new Teflon(R) seal to the pressure line fitting.





2. Position the power steering pump and install the 3 bolts.
^ Tighten to 25 Nm (18 lb-ft).
3. Connect the pressure line-to-pump fitting.
^ Tighten to 65 Nm (48 lb-ft).
4. Connect the power steering pump supply hose.
5. Install the power steering pump supply hose bracket bolt.
^ Tighten to 11 Nm (8 lb-ft).
6. Install the pressure line bracket-to-engine bolt.
^ Tighten to 11 Nm (8 lb-ft).
7. Install the power steering pump pulley.
8. Fill the power steering system.