Oil Pressure Sensor: Service and Repair

ENGINE OIL PRESSURE (EOP) SWITCH







Removal and Installation

1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls or the vehicle may be damaged.

Turn the ignition switch to the OFF position.

2. Remove the air cleaner outlet tube.
3. Disconnect the engine oil pressure (EOP) switch electrical connector.
4. Remove the EOP switch. Remove and discard the O-ring seal.
- To install, tighten to 14 Nm (124 lb-in).

5. NOTE: Apply clean engine oil to the O-ring seal prior to installation.

To install, reverse the removal procedure.
- Install a new O-ring seal.