Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Material:
Removal
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the output shaft speed (OSS) sensor.
Four wheel drive (4WD) vehicles
3. NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of foreign material to prevent contamination of the transmission.
Remove the OSS sensor.
1 Remove the bolt.
2 Remove the OSS sensor.
Rear wheel drive (RWD) vehicles
4. NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of foreign material to prevent contamination of the transmission.
Remove the OSS sensor.
1 Remove the bolt.
2 Remove the OSS sensor.
Installation
4WD vehicles
1. Install the OSS sensor.
1 Lubricate the O-ring with clean automatic transmission fluid and install the OSS sensor.
2 Install the bolt.
^ Tighten to 9 Nm (80 inch lbs.).
RWD vehicles
2. Install the OSS sensor.
1 Lubricate the O-ring with clean automatic transmission fluid and install the OSS sensor.
2 Install the bolt.
^ Tighten to 9 Nm (80 inch lbs.).
All vehicles
3. Connect the OSS sensor electrical connector.